Travelstar 10GT
Jumper settings |
Models: DCXA-208100 and DCXA-210000 |
A jumper is available at the interface
connector to determine the drive address. |
Note:
When cable selection is used (Jumper Pos 3 selected), the
drive address depends on the condition of pin 28 of the AT interface
cable. In the case when pin 28 is ground or low, the drive is a
master. If pin 28 is open or high level, the drive is a slave. |
 |
Shipping default settings |
The default setting of
jumper at shipment is No Jumper (Master). |
| |
